Here is "The Rework Eliminator" Header Kit as it arrived.

It is a very small kit. In terms of importance and value to the "K2" owner it's HUGE and almost priceless"

The Quick Start Instruction sheet is so small you might throw it out with the packing but don't do that. One single sheet with printing on both sides. Yup! That's it

Here is the PCB's picture both top [right] and bottom [left] sides

Here is the rest of the goodies......

BTW! DON'T DISCARD THAT HUNK OF PRETTY PINK FOAM!

That's it! 3 resistors, two capacitors, some SIP pins
Look close the 8 pin piece and the 3 pin piece have longer long pins.

Here is the PCB's completed picture both top [right] and bottom [left] sides
It takes longer to read the instructions than to install the parts.
Now! Where is that hunk of pretty pink foam?

After breaking apart the PCB's stick them into the foam so that they don't just rattle around inside something.
~ ~ ~ ~ ~

Now! Just why did I purchase the "Rework Eliminator" Header Kit? If I have a problem with any of the several options that I have installed in K2 #6321 I am able to remove the option and plug in the appropriate header and continue to use my radio. With out the header I would have restore the K2 to its before option state to use my K2. UGH! THAT'S TOO MUCH REWORKING.....

~ ~ ~ ~ ~

IF I HAD BEEN A TINY BIT SMARTER
I would have purchased the "OPTION READY KIT" and installed it during the K2 build then I would have ELIMINATED REWORKING my K2 to install the desired options. The options could then be installed any time I was ready to do so....

~ ~ ~ ~ ~

BTW I'm just a very satisfied customer.

For more information visit Rework Eliminators Web Site.